Traps the right selection guide Tianjin Yingqiao Valve Co., Ltd. ---- Li Shenghui, chairman of the board URL: Traps must choose the best quality products, limited funds should be used on the cutting edge. Use of high-quality trap to save energy and improve production efficiency than the purchase of the trap to invest several times higher. Selection of good quality traps can bring huge economic benefits to the enterprise. The use of traps wide range of large, must not be ignored, leaders at all levels should attach great importance. Select the trap requires accurate steam blocking drainage, high sensitivity, can improve steam utilization, no leakage of steam, reliable performance, high back pressure, long life, easy maintenance is the preferred conditions. 1. In the production process of heat exchange equipment, drying room, rapid heat exchangers, distillation equipment need rapid heating, does not allow the existence of condensed water production heating equipment, mechanical traps should be used. Mechanical trap is not affected by changes in temperature and pressure, water is row, low degree of supercooling, heating equipment without water, can make the heating equipment to achieve the best working temperature. One of the free float steam trap structure of the most advanced, very sensitive, the minimum degree of supercooling 0 ℃, the condensate can drain the saturation temperature, no leakage of steam, the advantages of up to enable the heating equipment to achieve the best efficiency. Is the ideal production process heating equipment trap. In the steam pipe, heating pipelines, heating equipment, low temperature requirements of steam equipment, should be selected thermostatically trap. Thermal static trap large degree of supercooling, condensate condensation water temperature is low, you can make full use of the sensible heat of high temperature condensate, energy saving effect is good. One of the most advanced membrane steam traps structure, without manual adjustment, very sensitive, the maximum degree of undercooling 15 ℃ and 30 ℃ for the selection of two kinds of membrane boxes, not afraid of freezing, small size, can be installed anywhere, In the pipeline can repair and replace the spool, saving money and labor, long service life, a wide range of applications, is the thermal static trap quality. 3 in the high temperature and pressure overheating steam lines and equipment, should be selected overheated steam steam trap. Superheat steam traps can separate high-temperature condensate generated when superheated steam disappears under harsh conditions of high temperature, high pressure, and light load. One of the disc-type steam insulation trap steam pipe steam trap on the main steam room insulation, advanced structure, in the absence of condensate, the trap tightly closed, high-quality work, long life, high pressure overheating Steam traps.