Nissei Plastic Industry Co., Ltd. has introduced a new series of injection molding machines "FNX" that uses a pump system consisting of a servo motor and a hydraulic pressure in a driving source. This pump system is already available in the "PNX" series launched in September 2005. By using the motor only when needed, about 10% less power is consumed in the 1078kN older product. There are 4 models, "FNX80-9A / 12A" with clamping force of 784kN and "FNX110-18A / 25A" with 1078kN. In terms of selling price, FNX80-9A is 8.9 million yen and FNX110-18A is 10.5 million yen.
Injection preparation time is reduced to the same electrical 45ms. Injection speed can be set between 1 ~ 300mm / second. Due to the small flux losses, drive measurements are reduced by up to 41% compared to older hydraulic presses. And further improve the repeatability, so as to control the instability of the quality of formed products to the past 1/3.
For the clamping structure, and PNX series using the same direct clamping mode. It is characterized by the mold can be evenly transmitted to the mold force, long-term maintenance of parallelism. Support mold thickness mold. In addition, you can shorten the time to replace the mold.